Panasonic TC-29P10N Service Manual page 10

Inspection and exchange of the rear termi-
nal switching board [H]
1. Remove the screws fixing the rear terminal cover (3
screws), disengage the locking tabs (4 places), and
remove the rear terminal frame.
Rear terminal frame screws (3 screws)
Rear terminal
switching board [H]
2. Disengage the cable (between H5 and L1) from the lead
clamp on the print holder, and tilt the rear terminal switch-
ing board [H] down to the front.
Lead clamp
Print holder
Rear terminal switching board [H]
Locking tab
Locking tab
Coupler H5
3. Inspection is possible in the following condition.
4. In case of exchange, disconnect the coupler H5 from the
rear terminal switching board [H], and disengage the cou-
pler in upward direction either in this condition or with the
rear terminal switching board [H] slightly raised.
Rear terminal switching board [H]
- 10 -
Coupler H5