Download Print this page

Finishing Instructions; Maintenance - Hearth and Home Technologies PHFR-MCE-36 Installation Instructions Manual

Ducted passive heat system for heat management for mezzo-c series, crave-c series, echelon-c series

Advertisement

6. Finishing Instructions

1. Apply wall sheathing material up to 1/2 inch thick up to
the edge of the plenum. See Figure 6.1.
WARNING! Risk of Overheating! DO NOT apply wall
sheathing past outside edge of plenum. Overheating of
appliance and combustible materials will occur.
2. Install the appropriate trim kit as instructed. See Table
1.1.
WARNING! Risk of Fire! DO NOT block passive heat
registers!
Overheating of appliance and combustible
materials will occur.
NO WALL SHEATHING MATERIAL BEYOND THIS LINE
NO WALL SHEATHING MATERIAL BEYOND THIS LINE
NO WALL SHEATHING MATERIAL BEYOND THIS LINE
NO WALL SHEATHING MATERIAL BEYOND THIS LINE
Figure 6.1 Wall Sheathing Installed
12
Hearth & Home Technologies • PHFR-MCE-36, PHFR-MCE-48, PHFR-MCE-60, PHFR-MCE-72 Instructions • 2560-972 • 6/20

7. Maintenance

Service and maintain the gas fireplace per instructions
included with the appliance. Keep the air register(s) clean
and free of any blockage.
Please contact your Hearth & Home Technologies
dealer with any questions or concerns.
For the location of your nearest Hearth & Home Technologies
please visit www.hearthnhome.com.
Hearth & Home Technologies
7571 215th Street West, Lakeville, MN 55044
www.hearthnhome.com
dealer,

Advertisement

loading