Clavia nord STAGE Service Manual page 15

Final assembly (pic.6)
When the Keybed is mounted according to the instructions in this document assemble
the unit again according to picture.
For information see section "opening the synth"
1. Place the upper lid including the wooden panels in position.
2. Attach the 2 rear "hinge" screws
3. connect the ribbon cables from the 2 panel boards.
4. Tighten the 10 screws
5. Tighten the 7 screws (
6. Tighten the 3 screws (
7. Mount the 2 bumpers.
Clavia DMI
(40038).
in the wooden panels.
(40038)
in the rear.
40018)
underneath the stage.
40018)
Service manual Nord Stage rev. 1.1
pic.6
Page 14