Table of Contents
Advertisement
How to remove the Interface Board
1)
Remove the Interface Board. (Fig. 1)
f Remove the four screws fixing the Interface Board by rotating
counterclockwise with a Phillips screwdriver. The removed screws are
used to fix the slot cover.
f Hold the handle of the Interface Board and remove it slowly.
2)
Attach the slot cover.
f Attach the stored slot cover to the blank slot, and tighten and fix with
the four screws removed in Step 1).
f To replace with other Interface Board, attach the Interface Board
following the procedure in "How to install the Interface Board"
(x page 9).
Attention
f Always attach the slot cover on the blank slot.
f Store the removed Interface Board inside an antistatic bag.
10 - ENGLISH
Installing the Interface Board
Handle
Fig. 1
Advertisement
Table of Contents
