Table of Contents
Advertisement
Faults, what to do?
Faults
Water is running out.
Water not flowing in.
Detergent not
dispensed.
Washing machine
door cannot
be opened.
Programme does
not start.
Detergent solution is
not drained.
Water not visible in
the drum.
Spin result not
satisfactory.
Washing wet/too
damp.
Spin cycle activated
several times.
Residual water in the
dispenser for care
product.
Odour formation in
the washing
machine.
Loud noise
formation, vibrations
and "wandering"
during spin cycle.
38
Cause/Remedy
– Correctly attach/replace drainage hose.
– Tighten screw-fitting on the supply hose.
– Avvio/Aggiungi bucato (Start/Reload)
– Tap not open?
– Filter blocked? Clean the filter. ~ Page 35
– Supply hose kinked or jammed?
– Safety function active. Stop programme?
$
– Rinse Hold
(without final spin) selected?
– Can be opened via emergency release only? ~ Page 36
– Avvio/Aggiungi bucato (Start/Reload)
Fine fra (Finished in) time selected?
– Door closed?
– Childlock active? Deactivate.
– Ammollo a fine lavaggio (Rinse Hold)
selected?
– Clean the drain pump.
– Clean outlet pipe and/or drainage hose.
Not a fault – water below the visible area.
– Not a fault – unbalanced load detection system has stopped the
spin cycle, washing unevenly distributed.
p
Distribute small and large items of washing in the drum.
– Easy-Iron
selected?
– Too low speed selected? ~ Page 22
Not a fault – unbalanced load detection system adjusts imbalance.
– Not a fault – effect of the care product not impaired.
– If required, clean insert. ~ Page 33
Run Cotone (Cottons) 90 °C programme without washing.
Use standard detergent.
– Appliance aligned?
Align the appliance. ~ Page 51
– Appliance feet fixed?
Secure appliance feet. ~ Page 51
– Transportation safety devices removed?
Remove transportation protection devices. ~ Page 46
A
not selected?
A
or
$
(without final spin)
Advertisement
Table of Contents
