Advertisement
2005 Matsushita Electric Industrial Co. Ltd.. All rights reserved.
Unauthorized copying and distribution is a violation of law.
1. Connection of the Speaker Cables
- Be sure to connect speaker cables before connecting the AC
power supply cord.
- The load impedance of any speaker used with this unit must be 5
- Be sure to connect the cable from the right speaker to the right
terminal and the cable from the left speaker to the left terminal.
1. Strip off the outer covering, and twist the center conductor. Make
sure the bare ends of the wires are not unravelled. (If they are,
twist them tight again.)
2. Insert the wire to the rear panel of the unit and close the lever.
Notes :
- To prevent damage to circuitry, never short-circuit positive (+) and
negative (-) speaker wires.
- Be sure to connect only positive (red) wires to positive (+)
terminals and negative (black) wires to negative (-) terminals.
Placement
Speakers are designed identically so that no left or right channel orientation is necessary.
Notes :
- Keep your speakers at least 10 mm away from the system for
PDF created with pdfFactory Pro trial version
2
www.pdffactory.com
.
Advertisement
