Changing Basic Settings - Bosch SPV4XMX28E User Manual

Basic setting
InfoLight
Tone volume
Wi-Fi
Remote start
Factory setting
1
Factory setting (may vary according to model)

Changing basic settings

Open the appliance door.
1.
Press ⁠ .
2.
To open the basic settings, press
3.
for 3 seconds.
a The display shows Hxx.
a The display shows
Display text Selection
1
I01 I00 - I01
1
b02 b00 - b03
1
Cn0 Cn0 - Cn1
1
rc1 rc0 - rc2
rE Start with
⁠ .
Description
Switch InfoLight on or off.
While the programme is running, a
spot of light is projected onto the
floor below the appliance door. This
light will not be visible if the appli-
ance is installed at eye level with the
cabinet front fitted flush. If the appli-
ance door is not completely closed,
the spot of light will flash. The pro-
gramme has ended when the spot of
light is no longer visible on the floor.
Level "I00" switches InfoLightoff.
Adjustment of tone volume.
Level "b00" switches the signal tone
off.
Switch the wireless network connec-
tion on or off.
Level "Cn0" switches the wireless
network connection off.
Activate or deactivate remote start.
The following settings are possible:
¡ With the "rc0" setting, remote
start is permanently deactivated.
¡ With the "rc1" setting, remote
start can be selected via the re-
mote start button.
→ "Remote start ", Page 37
¡ With the "rc2" setting, remote
start is permanently activated.
Restore changed settings to the fact-
ory settings.
The settings for initial start-up must
be configured.
Press
4.
the display shows the required set-
ting.
Press repeatedly until the dis-
5.
play shows the right value.
You can change several settings.
To save the settings, press
6.
for 3 seconds.
Close the appliance door.
7.
Basic settings en
repeatedly until
35