LENCO DVD-519 H User Manual page 24

All manuals and user guides at all-guides.com
Hue, to adjust the hue level of the video output
Luma delay, only adjust this setting if the audio and video signal are not in chorus
Resolution: This option must match with the HDMI resolution of the TV where the unit is
connected to, please refer to the instruction manual of the TV.
HDMI Setup: Here the HDMI setting can be set
HDMI: Set the HDMI output on or off
Audio format: Standard this option is set to auto. If the unit does not recognize HD
audio, there will be no sound. In this case set the audio format to PCM.
Audio setup page
Analogue audio setup: Here can the advanced analogues audio setting be set
Surround: select "5.1CH" for the optimal sound effect while playing a 5.1 CH or DTS
DVD. Select "LT/RT" to change the audio signal from 5.1 CH back to 2.1 CH (only if the
rear speakers and center speaker are not connected). For all other audio set this
function to "stereo".
Front, center, rear speaker: Select large to give these speakers an extra output power
boost
Subwoofer: Select on to activate the subwoofer, select off to deactivate the
subwoofer.
Dual Mono: This option is used to set the line out (see chapter advanced
connections) signal to stereo, left mono, right mono or mix mono (both channels
mono).
Dolby dynamic: Use this option to adjust the linear compression ratio if the line out is
active (this option is not available when under surround 5.1CH is selected).
Digital audio: here the digital output setting can be set.
Digital output: Select SPDIF / OFF to deactivate the digital audio output. Select SPDIF
/ RAW when the digital audio output is connected to an external audio device that
can decode Dolby digital. Select SPDIF / PCM when the digital audio output is
connected to an external 2CH digital audio device.
LPCM output: This option must match with the external device where the unit is
connected to, please refer to the instruction manual of the external device.
Channel delay: Here the distance from the sitting area to the speakers can be set to optimize
the sound effect.
For example: if the distance from the seat to the front speakers is 1,5 meter then the front speaker
distance must be set to 150 CM. If the subwoofer is next to the seat, the distance must be set to 0
CM and if the rear speakers are 20 CM behind the seat, the distance must be set to 20 CM.
24