Proper Burner Adjustment - Frigidaire FGC30S4HWA Owner's Manual

Sealed burner units porcelain enamel cooktop
Hide thumbs Also See for FGC30S4HWA:
Table of Contents

Advertisement

Available languages

Available languages

Proper Burner Adjustments
The color of the flame is the key to proper burner adjustment. A good flame is clear, blue and hardly visible in a well-lighted room.
Each cone of flame should be steady and sharply defined. Adjust or clean burner if flame is yellow-orange. To clean burner, see
instructions under General Cleaning. Each burner lights automatically from an electric ignitor each time a control knob is turned
to the LITE position.
Setting Surface Controls
To operate the surface burner:
Electric Ignition Models
In the event of an electrical power outage, the surface burners can be lit manually. To light a surface burner, hold a lit match to
the burner head, then slowly turn the surface control knob to LITE. Use caution when lighting surface burners manually.
Surface burner in use when an electrical power failure occurs will continue to operate normally.
Do not operate the burner for an extended period of time without cookware on the grate. The finish
on the grate may chip without cookware to absorb the heat.
Do not place plastic items such as salt and pepper shakers, spoon holders or plastic wrappings on top
of the cooktop when it is in use. These items could melt or ignite. Pot holders, towels or wood spoons could catch fire if placed
too close to a flame.
1. Place cooking utensil on burner.
2. Push in and turn the Surface Control knob to LITE. Note: All electronic ignitors will click at
the same time. However, only the burner you are turning on will ignite.
3. Visually check that the burner has lit.
4. After the burner lights, turn the control knob to the desired flame size. The control knobs do
not have to be set at a particular mark. Use the guides and adjust the flame as needed. DO
NOT cook with the control knob in the LITE position. (The electronic ignitor will continue to
click if left in the LITE position.)
5. To turn the burner off, turn the control knob as far as it ill go, to the OFF position.
Note: Control knob shown is typical only.
6

Advertisement

Table of Contents
loading

Table of Contents