Frigidaire FGC30S4HWA Owner's Manual page 11

General Cleaning
To Clean the Burner Grates, Burner Caps
Removable Burner Pans
To Clean Burner Caps (some models) and Removable Pans (some models)
Remove burner cap and pan. Use soap-filled pad or mild abrasive cleanser to clean
caps and pans. If necessary, cover stubborn spots with an ammonia-soaked paper
towel for 30 minutes. Rub gently with a mixture of clean water and vinegar. Wipe
dry. Remove all cleaners or the porcelain may become damaged during future
heating.
To Clean the Removable Burner Base and Gas Opening (some models)
The ports (or slots) around the burner base must be routinely cleaned. Use a small-
gauge wire or needle to clean small slots or holes. Use care to prevent damage to
the electrode. If a cleaning cloth should catch the electrode, it could damage or
break the electrode.
Note: If the electrode is damaged or broken, the surface burner will not light
because it will not spark. Manual lighting with a match is still possible.
For proper flow of gas and ignition of the burner - DO NOT ALLOW SPILLS, FOOD,
CLEANING AGENTS OR ANY OTHER MATERIAL TO ENTER THE GAS OPENING
TUBE. Gas must flow freely through the small hole in the brass orifice for the burners
to light properly. If the gas opening orifice becomes soiled or clogged, use a small-
gauge or needle to clean. ALWAYS keep the burner cap in place whenever a surface
burner is in use.
To Replace the Burner Base and the Burner Cap (some models)
Make sure the pieces are thoroughly dry before placing back.
1. Replace burner base and burner cap at there place. Make sure each burner cap
and burner base are properly aligned and leveled.
2. Replace the burner grate.
3. Turn the burner on to determine if it will light. If the burner does not light after
cleaning, contact an authorized servicer. Do not service the sealed burner
yourself.
(continued)
and Burner Bases
(some models)
,
(some models)
(continued)
11
Burner Cap
Burner
Base
Electrode
Sealed Burner
Gas
Opening