Maytag MGR8800FZ User Instructions page 16

The oven lights are 120 V, 40 W maximum halogen bulbs. They will
come on when the oven door is opened. The oven lights will not
work during the Self-Cleaning cycle.
When the door is closed, touch the appropriate Oven Light keypad
to turn on the oven light.
To Replace:
Before replacing the bulb, make sure the oven is off and cool.
1. Unplug range or disconnect power.
First try the solutions suggested here. If you need further assistance or more recommendations that may help you avoid a service call, refer
to the warranty, or visit http://www.maytag.com/product_help. In Canada, visit http://www.maytag.ca.
Contact us by mail with any questions or concerns at the address below:
In the U.S.A.:
Maytag Brand Home Appliances
Customer eXperience Center
553 Benson Road
Benton Harbor, MI 49022-2692
Please include a daytime phone number in your correspondence.
PROBLEM
Nothing will operate.
Surface burners will not
operate.
16
Oven Light
TROUBLESHOOTING
WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
POSSIBLE CAUSES
Power supply cord is unplugged.
Household fuse is blown or a
circuit breaker is tripped.
Main or regulator gas shutoff
valve is in the off position.
The range is improperly
connected to the gas supply.
The control knob is not set
correctly.
Air in the gas lines.
Clogged burner ports.
2. Unscrew the oven light globe then grasp the halogen bulb and
pull out.
3. Replace bulb, using tissue or wearing cotton gloves to handle
bulb. To avoid damage to or decreasing the life of the new bulb,
do not touch bulb with bare fingers.
4. Replace oven light globe by screwing it back into place.
5. Reconnect power.
In Canada:
Maytag Brand Home Appliances
Customer eXperience Centre
200 - 6750 Century Ave.
Mississauga, Ontario L5N 0B7
SOLUTIONS
Plug into a grounded 3 prong outlet.
Replace the fuse or reset the circuit breaker. If the problem
continues, call an electrician.
See the Installation Instructions.
Contact a trained repair specialist or see Installation
Instructions.
Push in knob before turning to a setting.
If this is the first time the surface burners have been used, turn
on any one of the surface burner knobs to release air from the
gas lines.
See "Sealed Surface Burners" section.