Specifications - JBL LS120P Service Manual

JBL

SPECIFICATIONS

Frequency Response
Amplifier RMS Power
Amplifier Peak Dynamic Power
Crossover Frequency
Driver
Dimensions (H x W x D)
(enclosed only)
Dimensions (H x W x D)
(with feet, controls, grille, etc.)
Weight
† The Peak Dynamic Power is measured by recording the highest center-to-peak voltage
measured across the output of a resistive load equal to minimum impedance of the transducer,
using a 50Hz sine wave burst, 3 cycles on, 17 cycles off.
Declaration of Conformity
We, Harman Consumer Group, Inc.
2, route de Tours
72500 Château du Loir
France
declare in own responsibility that the product
described in this ownerʼs manual is in compliance
with technical standards:
EN 61000-6-3:2001
EN 61000-6-1:2001
Laurent Rault
Harman Consumer Group, Inc.
Château du Loir, France 5/07
†
Declaration of Conformity
We, Harman Consumer Group, Inc.
2, route de Tours
72500 Château du Loir
France
declare in own responsibility that the product
described in this ownerʼs manual is in compliance
with technical standards:
EN 55013:2001+A1:2003
EN 55020:2002+A1:2003
EN 61000-3-2:2000
EN 61000-3-3:1995+A1:2001
EN 60065:2002
LS 120P
25Hz – 150Hz
400 Watts
700 Watts
50Hz – 150Hz;
24dB/octave, continuously adjustable
300mm (12") PolyPlas
™
487mm x 375mm x 425mm
(19-3/16" x 14-3/4" x 16-3/4")
500mm x 375mm x 438mm
(19-11/16" x 14-3/4" x 17-1/4")
25.8kg (57 lb)
Laurent Rault
Harman Consumer Group, Inc.
Château du Loir, France 5/07
LS 120P EuP/230 Service Manual
Page 4 of 25