Adjusting The Volume - Canon ELURA 80 Instruction Manual

Adjusting the Volume

When you use the LCD screen for playback, the camcorder plays back the sound via
built-in speaker. The speaker does not sound when you close the LCD panel. Use
headphones when using the viewfinder.
SET dial
When Using Headphones
The headphones terminal also serves as AV terminal. Headphones can only be used
when " " is displayed on the screen. If not, change the setting following the procedure
below.
CAMERA
MENU
VCR SETUP
( 38)
Open the menu and select [VCR SETUP]. Select [AV/PHONES
[PHONES ] and close the menu.
The speaker does not sound when " " is displayed.
Do not connect headphones unless " " is displayed as it produces noise.
Adjusting the Volume
CAMERA
Turn the SET dial up to increase the volume, and down
to lower the volume.
• A volume bar appears for 2 seconds.
• You can turn off the volume completely by turning the SET dial
down until [OFF] appears. Turn the SET dial up to increase the
volume again.
PLAY (VCR)
PLAY (VCR)
(phones) terminal
Speaker
CARD CAMERA
AV/PHONES ••AV
CARD CAMERA
E
CARD PLAY
], set it to
CARD PLAY
35