Connect Dc Power To A Pa-220R Firewall - PaloAlto Networks PA-220R Hardware Reference Manual

Connect Power to a PA-220R Firewall

Connect DC Power to a PA-220R Firewall

The following procedure describes how to connect DC power to a PA-220R firewall. Before you
connect power, read the
a PA-220R Firewall. The DC terminal block for connecng the DC power cables to the firewall is
included in the PA-220R accessories kit.
To avoid injury to yourself or damage to your Palo Alto Networks
that resides on the hardware, read the
Power off the DC power sources that you will connect to the power supplies before you
connue.
STEP 1 | Verify that the DC power source that will power the firewall is powered off.
In the following procedure, connect the DC power cables—and ground cable if you do
not use the screw-on ground point—to the DC terminal block before you aach the DC
terminal block to the firewall.
STEP 2 |
Connect one end of a 16-22AWG ground cable to the firewall and connect the other end to
earth ground. There are three ground locaons on the firewall: one screw-on ground point
above the DC power inputs and two ground inputs on the DC terminal block (last two inputs
to the right of the DC inputs); use only one of the three ground locaons even if you will
connect a second set of DC power cables for redundancy.
• Screw-on ground point
point, hold the 6-32 ring lug (that you previously aached to the ground cable) over the
screw hole, and then re-aach the screw to secure the cable to the firewall. Do not torque
the screw to more than 6 in-lbs.
• DC terminal block ground inputs
input terminals and then secure the cable by turning the flat-head terminal screw clockwise.
Do not torque the terminal screws to more than 2 in-lbs.
PA-220R Next-Gen Firewall Hardware Reference
PA-220R Electrical Specificaons
Product Safety
(Opon 1)—Remove the ground screw from the screw-on ground
(Opon
29
and Prepare to Connect DC Power to
hardware or the data
®
Warnings.
2)—Insert the cable into one of the two ground
2021 Palo Alto Networks, Inc.
©