Table of Contents
Advertisement
HCS-3020 4020
After engine warm-up, grip the throttle handle with left hand and support
handle with right hand. Depress the throttle trigger lockout, and gradually
depress throttle trigger to increase engine RPM to operating speed.
Starting Warm Engine
The starting procedure is the same as Cold Start except DO NOT close the
choke.
The blades must not move at
idle, otherwise serious personal
injury may result. Periodic
carburetor adjustment may be
necessary to assure blades do
not move at idle. If blades move,
readjust carburetor according to
"Carburetor Adjustment"
instructions in this manual or see
your ECHO Dealer.
1.
Stop Switch
Move stop switch (A) away from
the STOP position.
2.
Purge Bulb
Pump purge bulb (C) until fuel is
visible and flows freely in the clear
fuel tank return line. Pump bulb an
additional 4 or 5 times.
3.
Recoil Starter
Place the unit on a flat, clear area.
Grip the support handle securely
with right hand, and pull the recoil
starter handle (D) with left hand
until engine fires.
Note: If engine does not start
after 5 pulls, use Cold Start
Procedure.
X7702243800
© 3/2016 ECHO Inc.
A
B
C
D
OPERATION
21
Advertisement
Table of Contents
