Using The Light Off Function; Using The Auto Clean Function - LG JW-Q24WUZA Owner's Manual

14 OPERATION
Clean Filter
6
The Clean Filter LED lights up to notify you
together on the control panel to turn off the
Clean Filter light.
NOTE
●
control panel, not the remote control.
● This feature is a reminder to clean the air
light turns on after 250 hours of operation.
Fan Speed
7
Press to set the fan speed to Low (F1),
Medium (F2), or High (F3).
Temperature Control
8
The thermostat monitors room temperature
to maintain the desired temperature. The
thermostat can be set between 16 °C–30 °C
(60 °F–86 °F). Press
increase or decrease temperature setting.
Energy Saver
9
In this mode the compressor and fan turn
off when the set temperature is achieved.
Approximately every 3 minutes the fan turns
on to allow the unit sensor to accurately
determine if more cooling is needed.
NOTE
● This function is available with Cooling
Mode.
Clear
10
Cancel Sleep and Timer settings. Also set
the Diagnosis if held for 5 seconds.
NOTE
● Auto Restart: If the air conditioner turns off due
to a power outage, it will restart automatically
once the power is restored, with the same
settings as were set before the unit turned off.
● Energy Saver: The unit defaults to the Energy
Saver mode each time the unit is switched on
except in Fan mode or when power is restored
after an electrical power outage.
● The remote control will not function properly if
the AC infrared sensor is exposed to direct light
or if there are obstacles between the remote
controller and the air conditioner.
● Default temperature will be minimum 24 °C (in
cooling cycle), when operated with remote
control except power failure/power switched
off.

Using the Light Off Function

You can set the brightness of the control panel.
Temp and
● Press Mode button on the remote control for
● Press Mode and Sleep button together on the
NOTE
● Turn on/off the control panel.

Using the Auto Clean Function

In the Cooling and Dry Mode, Moisture is
generated inside the indoor unit. This function
removes such moisture.
● Press Energy Saver button on the remote
●
or arrows to
NOTE
● If you turn off the unit, the fan continues to run
3 seconds, or
control panel．
control for 3 seconds.
is displayed on the remote control.
for 10 minutes and cleans the inside of the
indoor unit.