Table of Contents
Advertisement
6. Place a container under the portafilter and frothing wand
(A8) (fig. 11);
7. Press the button (B4) corresponding to the
livery begins (fig. 12);
8. When delivery is complete, turn the steam dial (A4) (fig. 13)
and deliver steam for 10 seconds to rinse the steam circuit;
9. Repeat points 7 and 8 until you have delivered at least 1
litre of water (about half the tank);
10. Remove the water tank (A17) (fig. 3), rinse and fill with fresh
clean water, taking care not to exceed the MAX level (fig. 4).
The appliance is ready for use.
Please note:
We also recommend rinsing the internal circuits if the appliance is
not used for a long period.
The first time you use the appliance, you need to make 4-5 cups
of coffee before the appliance starts to give satisfactory results.
Pay particular attention to the quantity of pre-ground coffee in
the filter ((C2) or (C3)) (see instructions in section "4.4 Adjusting
the quantity of ground coffee in the filter").
Proceed as described in section "4. Prepare the perfect coffee
dose".
4. PREPARE THE PERFECT COFFEE DOSE
4.1 Preparing the coffee grinder
1. Make sure the bean container is correctly inserted and
lined up to position "3" (fig. 14) (factory setting);
2. Remove the bean container lid (A1);
3. Place the required quantity of coffee beans in the container
(fig. 15);
4. Close the lid, pressing firmly.
5. The first time you use the appliance, make sure the dial (B2)
is in the
position (default setting).
4.2 Select the coffee grinding (coarse to fine)
The grinding level affects delivery speed and therefore the qual-
ity of the coffee extraction.
The first time you use the machine, we recommend using the
factory setting (medium grinding, setting "3") (fig. 14), then if
you are not satisfied with the result, adjust the level according
to your personal taste and the type of coffee by setting a finer
(setting "1") or coarser grinding level (setting "6"), referring to
the tips in section "4.4 Adjusting the quantity of ground coffee
in the filter".
Important:
•
Always adjust the coffee grinder while in opera-
tion.
•
Adjust one grinding level at a time and make at least 5 coffees
before adjusting again.
•
Do not remove the bean container while it contains beans.
•
If you want to use a flavored coffee, please use preground
coffee in the portafilter as opposed to flavored beans. See
section"7. Using pre-ground coffee".
4.3 The coffee filters
The appliance is provided with two coffee filters.
light. De-
The 1 coffee filter (C2) has the
bottom.
The 2 coffee filter (C3) has the
bottom.
For the perfect coffee dose, the ideal level of tamped coffee is
marked inside the filters (fig. 16). If the quantity is above or
below the level indicated, the result may not be satisfactory.
The next times you use the coffee grinder, you can adjust the
grinding level using the dial (B2) (see section "4.4 Adjusting the
quantity of ground coffee in the filter").
4.4 Grind the coffee directly into the filter
1. Place the ground coffee filter (C2) or (C3) in the portafilter
(C1) (fig. 17);
2. Press the "X2" button if you are using the 2 coffee filter;
3. Attach the portafilter to the outlet of the coffee grinder
(A22), aligning it with "INSERT", then turning it to the right
(fig. 18). Grinding begins when the portafilter reaches the
CLOSE position and stops automatically;
Important: while the appliance is grinding coffee, you can per-
form a rinse, or produce hot water or steam at the same time.
4. Once grinding is complete, the
the tamping lever (A23) as far as it will go. The force exerted
on the coffee is indicated on the lever itself (
(fig. 19). The
5. Remove the portafilter by turning it towards the left.
Important:
•
To adjust the correct quantity ground automatically into the
portafilter, see section "4.4 Adjusting the quantity of ground
coffee in the filter".
•
A second grinding cycle could begin if portafilter is removed
before grinding cycle is completed and portafilter reinserted.
Please listen for grinding to complete before adjusting porta-
filter or tamping.
If you remove the portafilter from the outlet of the coffee grind-
er without tamping the coffee, the
press, turn the dial (B2) to the
mill, re-attach the portafilter and pull the lever (A23).
4.5 Adjusting the quantity of ground coffee in
the filter
Important: The first time you use the coffee grinder, leave the
ground coffee quantity dial (B2) in the
mal for you to have to grind the coffee a number of times before
finding the correct adjustment for the perfect coffee dose.
8
symbol marked on the
symbol marked on the
light (B16) flashes. Pull
light remains on steadily.
light (B16) flashes. To
position to disable the coffee
position (min). It is nor-
)
Hide quick links:
Advertisement
Table of Contents
