Care And Cleaning; Regular Cleaning - LG WM2010CW User's Manual & Installation Instructions

REGULAR CLEANING

wWARNING:
• Unplug the washer before cleaning to avoid the risk of electric shock. Failure to follow this warning
can cause serious injury, fire, electrical shock, or death.
• Never use harsh chemicals, abrasive cleaners, or solvents to clean the washer.
They will damage the finish.
Cleaning the Exterior
Proper care of your washer can extend its life. The
outside of the machine can be cleaned with warm
water and a mild, nonabrasive household detergent.
Immediately wipe off any spills with a soft, damp
cloth.
IMPORTANT: Do not use methylated spirits, solvents,
or similar products.
Never use steel wool or abrasive cleansers; they can
damage the surface.
Care and Cleaning of the Interior
Use a towel or soft cloth to wipe around the washer
door opening, door seal, and door glass. These areas
should be kept clean to ensure a watertight seal. Be
sure to wipe under the inside rubber seal to remove
any moisture or soil.
Always remove items from the washer as soon
as the cycle is completed. Leaving damp items in the
washer can cause wrinkling, color transfer, and odor.
Run the TUB CLEAN cycle regularly to remove
detergent buildup and other residue.
NOTE: If you use the TUB CLEAN cycle on a monthly
basis, the wash drum will be kept clean.
Removing the Stain in Door Seal
NOTE: Wear rubber gloves and eye protection while
performing the following procedure:
Dilute 3/4 cup (177 ml) liquid chlorine bleach with
1
1 gallon (3.8 L) of warm/hot water.
Use this solution to wipe down all surfaces of
2
the gasket to remove the deposits that are causing
any odor. (Be sure to fold back the lip of the gasket
to get under the edge where residue can build up.)
3 Wipe the gasket with a dry cloth.
Leave the door open to allow the gasket to dry
4
completely.
Do not use undiluted bleach as this will damage the
gasket.Follow the manufacturer's instructions for proper
use of bleach.
If the gasket cannot be cleaned properly, it should be
replaced.
C A R E A N D C L E A N I N G
Storing the Washer
If the washer will not be used for an extended
period of time and is in an area that could be
exposed to freezing temperatures:
1 Turn off water supply tap.
Disconnect hoses from water supply and
2
drain water from hoses.
Plug the power cord into a properly grounded
3
electrical outlet.
4 Add 1 gallon of nontoxic recreational vehicle
(RV) antifreeze to the empty wash drum.
Close door.
5 Select the spin cycle and let washer spin
for 1 minute to drain out all the water.
NOTE: Not all of the RV antifreeze will be
expelled.
Unplug the power cord, dry the drum interior
6
with a soft cloth, and close the door.
7 Remove the inserts from the dispenser. Drain
any water in compartments and dry the
compartments.
8 Store the washer in an upright position.
9 To remove the antifreeze from the washer
after storage, run washer through a complete
cycle using detergent. Do not add laundry!
Removing Lime Buildup
If you live in an area with hard water, lime scale
can form on internal components of the washer.
Use of a water softener is recommended in areas
with hard water. If a descaler is used, make sure
that it is suitable for use in a washer, and run the
TUB CLEAN cycle before washing clothing.
Lime scale and other spots may be removed
from the stainless steel drum using a stainless
steel cleaner. Do NOT use steel wool or abrasive
cleansers; they can damage the surface.