Bose PACKLITE A1 Manual page 32

DISASSEMBLY PROCEDURES
5. LED PCB Removal
5.1 Perform procedure 1.
5.2 Unplug the wiring harness from the input
/ limiter PCB (9) for the LED PCB (2 or 19)
that you wish to remove. These harnesses
unplug from the connector at the LED PCB
end of the harness.
5.3 Using a small Phillips-head screwdriver,
remove the two screws that secure the LED
PCB to the upper housing. Lift the PCB off of
the LED lens (20).
Re-assembly Notes:
1. Be sure to align the light pipe with the
upper housing and to align the LED PCB
with the four tabs on the LED lens.
2. Make a note of the direction that the LED
PCB mounts to the upper housing. If you re-
install it backward, the LED harness will
interfere with the power supply caps during
re-assembly.
6. Rear Panel Removal
6.1 Perform procedure 1.
6.2 Unplug the AC wiring harness from the
power supply / amplifier PCB (8) at CON300.
6.3 Using a Phillips-head screwdriver,
remove the screw that secures the AC wiring
harness ground lug to the lower chassis
housing. Retain the screw and washer for
re-use.
32