Table of Contents
Advertisement
Installation
Pass the refrigerator laterally through the access
Pass the
refrigerator
door as shown in the right figure.
Install the freezer and refrigerator
compartment doors
Water supply installation
Before
installation
Warning
Disposal of the
This appliance contains fluids (refrigerant and lubricant) and is made of parts and
old appliance
materials which are reusable and/or recyclable.
All the important materials should be sent to the collection center of waste material
and can be reused after rework (recycling). For recycling, please contact the local
agency.
Mount them in the reverse sequence of removal after they pass through the access
door.
Automatic icemaker operation needs water pressure of 21~121 psi (1.5~8.5
kgf/cm
2
) (That is, an instant paper cup (6 oz. or 180 cc) will be fully filled within
3 seconds.)
If water pressure is less than 21 psi (1.5 kgf/cm
separate pressure pump for normal automatic icemaking and cool water feed.
Keep the total length of the feed water pipe tube within 26' (8 m). Be careful for the
tube to avoid being kinked. If the tube is longer than 26' (8 m), the pressure may
drop to an unacceptable level.
Install the water supply line where it will not be affected by heat.
Connect to potable water supply only.
2
). It is necessary to purchase a
Advertisement
Table of Contents
