Table of Contents
Advertisement
INSTALLING THE SANDING BELT
ASSEMBLY
1.
Slide Belt Assembly down Motor Shaft
Drum Spline
with the slots in the fan. Place
B
Sanding Belt Assembly
opening as shown.
2.
Tighten Spindle Knob
NOTE: Knob turns counterclockwise to tighten.
3.
Install Sanding Belt, see Removing/Installing the
Sanding Belt section.
See Figure 1.
Removing the Sanding Belt
Assembly
To reduce the risk of injury from accidental
start, make sure tool is unplugged before removing the sanding
belt assembly.
1.
Loosen the work rest knob
out of the way. Tighten the work rest knob.
2.
Remove the spindle knob
. NOTE: Knob turns clockwise to loosen.
assembly
PC12
3.
Store assembly on bracket in rear of base.
See Figure 2.
ASSEMBLY
. Align Drive
A
into the Wear Plate
PC12
. DO NOT overtighten.
HP12
and pivot the work rest
HP13
and lift off the sanding belt
HP12
HP12
C
B
HP12
HP13
14
PC12
C
A
FIGURE 1
PC12
FIGURE 2
Advertisement
Table of Contents
