Ariston AQXL 85 Instruction Booklet page 2


Keep this instruction manual in a safe place for
future reference. If the appliance is sold, given away
or moved, please ensure the manual remains with the
machine so that the new owner may benefit from the
advice contained within it.

Please read this instruction manual carefully it
contains important information regarding the safe
installation, use and maintenance of the appliance.

You will find the guarantee and other details relating to
the installation process in the bag containing this booklet.
1. Once the washing machine has been removed
from the packaging, check that it has not been
damaged during transportation.
If it has been damaged, contact the retailer and do
not proceed any further with the installation process.
3. Having removed the 4 bolts use the 4 plastic
blanking plates to cover the 4 holes.
4. Keep all the pieces; if the washing machine is
transported in future, the transit bolts and spacers will
have to be replaced in order to avoid damaging the
inside of the machine.

Packaging materials should not be used as toys by children.
1. Position the washing machine on a level and sturdy
floor, without resting it against walls or cabinets.

If the appliance is levelled correctly it will be more
stable and much less likely to cause vibrations and
noise during the spin cycle.
All manuals and user guides at all-guides.com
2. Remove the 4 transit
bolts used during
transportation and the
corresponding spacers
on the back of the
machine (see figure).
2. If the floor is uneven,
the feet of the appliance
may be adjusted until it
reaches a perfectly
horizontal position (the
angle of inclination must
not exceed 2 degrees).

If positioned on a fitted carpet or a rug, adjust the
feet in such a way as to allow room for air to circulate
and provide ventilation beneath the washing machine.

Before connecting the inlet hose to the cold water supply,

allow the water to flow from the tap until it runs clear.
A
3. Make sure there are no kinks or bends in the inlet hose.

The water pressure at the tap must fall within the values
indicated in the Technical data table (see next page).

If the water inlet hose is not long enough, contact a
specialist store or an authorised technician.

Always use the new water inlet hoses supplied with
the machine.
1. Connect the inlet hose
to the machine, by
screwing it into the cold
water inlet on the upper
right hand side of the
back of the machine (see
figure).
2. Place the seal A
(provided in the bag) on
the end of the inlet hose
and screw it to a cold
water tap with a 3/4 BSP
threaded connection (see
figure).