Factory Defaults; Warnings And Cautions - Kasda KW58193 User Manual

Wireless ADSL Modem
 Subscription for ADSL service. Your ADSL service provider should provide
you with at least one valid IP address (static assignment or dynamic
assignment via dial-up connection).
 One or more computers, each contains an Ethernet 10/100M Base-T
network interface card (NIC).
 A hub or switch, if you are connecting the device to more than one
computer.
 For system configuration using the supplied web-based program: A web
browser such as Internet Explorer v5.0 or later, or Netscape v4.7 or later.
1.4

Factory Defaults

The device is configured with the following factory defaults:
 IP Address: 192.168.1.1
 Subnet Mask: 255.255.255.0
 Encapsulation: LLC/SNAP-BRIDGING or VC/MUX
 VPI/VCI: According to local information
1.5

Warnings and Cautions


Never install telephone wiring during storm. Avoid using a telephone during
an electrical storm. There might be a risk of electric shock from lightening.

Do not install telephone jacks in wet locations and never use the product
near water.

To prevent dangerous overloading of the power circuit, be careful about the
designed maximum power load ratings. Not to follow the rating guideline
could result in a dangerous situation.

Please note that telephone line on modem must adopt the primary line that
directly outputs from junction box. Do not connect Router to extension
phone. In addition, if your house developer divides a telephone line to multi
sockets inside the wall of house, please only use the telephone that has
connected with the splitter of ADSL Router when you access the Internet.
Under the above condition, if you also install telephone with anti-cheat-dial
device, please pull out this kind of telephone, otherwise ADSL Router may
occur frequently off-line.
4
USER MANUAL