Table of Contents
Advertisement
Installing and Composition
Installation Instructions
* Don't place the projector in the following conditions. It may cause malfunction or product damage.
Provide proper ventilation for this projector.
G
The projector is equipped with ventilation holes(intake)
on the bottom and ventilation holes(exhaust) on the front.
Do not block or place anything near these holes, or inter-
nal heat build-up may occur, causing picture degradation
or damage to the projector.
G
Never push projector or spill any kind of liquid into the
projector.
Place this projector in adequate temperature and humidity conditions.
G
Install this projector only in a location where adequate temperature and humidity is available. (refer p.41)
Don't place the projector where it can be covered with dust.
G
This may cause overheating of the projector.
Do not obstruct the slots and openings of the projector. This may cause overheating and create a fire
hazard.
The projector is manufactured using high-precision technology. You may, however, see tiny black points
and/or bright points (red, blue, or green) that continuously appear on the projector Screen. This is a nor-
mal result of the manufacturing process and does not indicate a malfunction.
To display DTV programs, it is necessary to purchase a DTV receiver (Set-top Box) and connect it to the
projector.
When the remote control does not work during operation.
G
The remote control may not work when a lamp equipped with electronic ballast or a three-wavelength lamp is installed.
Replace those lamps with international standard products to use the remote control normally.
G
Do not place the projector on a carpet, rug or other
similar surface. It may prevent a adequate ventilation
of the projector bottom. This product should be
mounted to a wall or ceiling only.
G
Leave an adequate distance(30cm/12 inches or
more) around the projector.
Installing and Composition
11
Advertisement
Table of Contents
