On First-Time Startup - Pioneer AVH-X390BT Operation Manual

Basic operation
Plugging and unplugging a USB stor-
age device
p This product may not achieve optimum performance with
some USB storage devices.
p Connection via a USB hub is not possible.
p A USB cable is required for connection.
1 Pull out the plug from the USB port of the USB
cable.
2 Plug a USB storage device into the USB cable.
1
2
1 USB cable
2 USB storage device
Check that no data is being accessed before pulling out the
USB storage device.

On first-time startup

1 Start the engine to boot up the system.
The "Select Program Language" screen appears.
p From the second time on, the screen shown will differ
depending on the previous conditions.
2 Touch the language.
3 Touch .
The "Speaker Mode Settings" screen appears.
4 Touch the speaker modes.
 Standard Mode
4-speaker system with front and rear speakers, or a
6-speaker system with front and rear speakers and
subwoofers.
 Network Mode
3-way system with a high range speaker, middle range
speaker and subwoofer (low range speaker) for reproduction
of high, middle and low frequencies (bands).
WARNING
Do not use the unit in standard mode when a speaker system
for 3-way network mode is connected to this unit. This may
cause damage to the speakers.
5 Touch [OK].
The "Smartphone Setup" screen appears.
6 Touch the item.
 Refer to Information on the connections and functions for
each device on page 15
7 Touch .
The top menu screen appears.
p Once the speaker mode is set, the setting cannot be
changed unless this product is restored to the default
settings. Restore the default settings to change the speaker
mode setting.
 Refer to Restoring the default settings on page 43
Switching the speaker mode
To change the speaker mode, you need to restore this product to
the default settings.
1 Restore the default setting.
 Refer to Restoring the default settings on page 43
7