Gear Case - Echo ProPaddle SRM-2400SB Operator's Manual

LUBRICATION
12. Reinstall right ProPaddle sweeper drum assembly and secure with split
pin.

Gear Case

The gearcase should be filled with 60 cc (2.0 fl.oz.) of Mobil SHC634
Synthetic Gear Oil. A maximum of 75-80 cc can be used, but never to
exceed 80 cc. Operation with excessive oil level will result in high operating
temperatures. Do not overfill when replacing the gearcase oil.
BURN DANGER! The gearcase will be extremely hot after use!
1. Disconnect spark plug wire at
engine.
2. Remove the LH Drum and axle
assembly (as viewed from the
operating position). Wipe the
side-plate clean and remove
four screws (it is not necessary
to remove the gearcase from
the outer tube).
3. Turn gearcase side plate to
break the seal and lift the plate
from the gearcase.
Note: It may be necessary to
use a heat gun to soften the sealer material.
4. Turn gearcase side plate to
break the seal and lift the plate
from the gearcase.
5. Place the gearcase on the RH
side and supported so the outer
tube is parallel to the ground.
Refill the gearcase with 60 cc
(2.0 fl.oz) of Mobil SHC634
Synthetic Gear Oil to the
bottom of the chamfer on the
output gear. The correct oil
depth is 5/8 in. (15.5 mm). DO
NOT OVERFILL!
6. Inspect the side-plate for
damage and clean off all remaining liquid gasket material with brake
cleaner or acetone. Coat the outer sealing flange of the side-plate with
silicon sealant.
22
99944200620
X7532093907
© 1/2017 ECHO Inc.