Table of Contents
Advertisement
EN
14
INSTALLATION
manufactured by LG Electronics for use with this
model.
2
Check if the appliance is perfectly level using a
spirit level
.
a
3
Secure the levelling feet with the lock nuts
by turning anti-clockwise against the bottom of
the appliance.
4
Check if all lock nuts at the bottom of the
appliance are secured properly.
NOTE
• Proper placement and levelling of the appliance
will ensure long, regular, and reliable operation.
• The appliance must be 100% horizontal and
stand firmly in position on a hard flat floor.
• It must not 'Seesaw' across corners under the
load.
• Do not let the feet of the appliance get wet.
Failure to do so may cause vibration or noise.
Connecting the Water
Supply Hose
Note for Connection
• Water pressure must be between 100 kPa and
1000 kPa (1.0‒10.0 kgf/cm²). If the water
pressure is more than 1000 kPa, a
decompression device should be installed.
• Periodically check the condition of the water
supply hose and replace the water supply hose if
necessary.
NOTE
• Do not overtighten the water supply hose or use
b
mechanical devices to tighten onto the inlet
valves.
• No further backflow protection required for
connection to the water inlet.
Checking the Rubber Seal
Two rubber seals
supply hose. They are used for preventing water
leaks. Connection to taps is sufficiently tight.
• Do not use mechanical devices such as multi
grips to tighten the water supply hose. Ensure
are supplied with the water
a
Advertisement
Table of Contents
