Table of Contents
Advertisement
Section 1: Assembly & Setup
37298
Hook-up Transport Frame
!
WARNING
To avoid serious injury or death:
•
Lightweight tractors with rear attached implements may
need weights added to the front to maintain steering control.
Consult your tractor Operator's Manual to determine
proper weight requirements and maximum weight
limitations.
•
Jack must be installed on the hitch and jack attachment pin
must be fully inserted and secured before working on or
around an implement not hooked to the tractor drawbar.
Refer to Refer to Figure 1-5:
1.
Make certain park jack (#1) is attached to the
transport frame and secured with retaining pin (#2).
2. Back tractor within close proximity of clevis (#3).
3. Raise or lower park jack (#1) to align clevis (#3) with
tractor drawbar. Drawbar should fit between lower
and upper clevis plates.
4. Back tractor up to transport frame hitch until holes in
tractor drawbar and clevis (#3) align.
5. Attach transport frame with 1" hitch pin (#4) and
secure hitch pin with hairpin (#5). Always use a hitch
pin with a safety lock to prevent pin from coming out.
6. Retract park jack (#1) until weight of transport frame
is fully removed from the jack. Remove jack and store
on storage tube (#7).
7.
Attach safety chain (#6) on the hitch to the tractor.
Adjust chain length to remove all slack except what is
necessary to permit turning of mower. Lock chain
hook securely onto the chain.
8. Continue with "Hook-up Hydraulics". Installation of
main driveline (#8) on page 20 will be completed
later.
11/18/21
Table of Contents
Tractor Hook-Up
Figure 1-5
Hook-up Hydraulics
Refer to Figure 1-6:
This mower is equipped and plumbed from the factory
with double acting cylinders, hydraulic hoses, and
couplings for folding the wings and center deck.
1.
Cut plastic ties securing hydraulic hoses (#1) to hose
support loop (#2).
2. Route hoses (#1) through hose support loop (#2) and
connect to tractor remote outlets. Quick disconnect
hydraulic fittings for your tractor are supplied
attached to the hoses.
3. Locate carbon steel wire (#3) attached between wing
cylinders (#4). This wire secures the wing tool bars in
the folded position during shipment. Remove wire
and dispose of it in a trash container.
Hydraulic Hook-up
Figure 1-6
AFM4522 All-Flex Grooming Mower 315-360M
70118
26622
17
Advertisement
Table of Contents
