Table of Contents
Advertisement
Section 1: Assembly & Setup
Deck Gauge Wheel Assembly
Refer to Figure 1-1 and Figure 1-2:
1.
Remove mower decks (3 each) from their shipping
crates. Set each deck on a working stand capable of
supporting the decks high enough to install gauge
wheel assemblies (#1).
2. Assemble gauge wheel yoke assemblies (#1) to the
decks with hardware indicated. 6 gauge wheel
assemblies are caster yoke with round shafts and 4
assemblies are non-caster yoke with square shafts.
See Figure 1-1 and Figure 1-2 for correct location of
caster and non-caster assemblies.
IMPORTANT: Be sure to position equal size and
amount of spacers under each spindle. See "Center
Deck Height Adjustments" on page 25.
1557
Center Deck Gauge Wheel Assembly
Figure 1-1
Wing Deck Gauge Wheel Assembly
Figure 1-2
16
AFM4522 All-Flex Grooming Mower 315-360M
Table of Contents
Refer to Figure 1-3:
3. Remove mower decks from their working stands and
position them on a level surface in the arrangement
shown. Left, and right wing gearbox input shafts
should point towards each other.
Power Take-Off To Drawbar Set-Up
Refer to Figure 1-4:
!
WARNING
To avoid serious injury or death:
•
Select a safe ground speed that will allow adequate control
of steering and stopping. Never exceed 20 mph (32.2 km/h)
with attached equipment. Rough terrain requires a slower
speed.
•
Power take-off damage may occur if distances are not
properly maintained.
The 14" (35.6 cm) distances between center of drawbar
hitch pin hole to end of tractor power take-off shaft and
8" (20.3 cm) distance from top of drawbar hitch to center
of power take-off shaft must be maintained.
22273
15613
Deck Location
Figure 1-3
14"
(35.6 cm)
Power Take-Off Shaft
Drawbar
Ground Level
Power Take-Off to Drawbar Distances
Figure 1-4
15584
8"
(20.3 cm)
18" to 21"
(45.7cm to 53.3 cm)
11/18/21
Advertisement
Table of Contents
