ADTRAN 401 1 GE Micro ONT Quick Start

Quick Start
D
ESCRIPTION
The ADTRAN 401 1 GE Micro ONT is an Optical Network
Terminal (ONT). It is a member of the Micro ONT family
supporting auto-detection of Active Ethernet and GPON network
connections for use in point-to-point and point to-multipoint optical
distribution networks (ODNs).
Figure 1 illustrates the key features on the Micro ONT.
1
4
Figure 1. Micro ONT Key Features
The table opposite provides descriptions for each feature number
above.
ADTRAN 401
Micro ONT
1 GE
LAN
FIBER
POWER
2 3
5
Number Feature
1 Single GPON and Active Ethernet fiber interface with
1.244 Gbps upstream and 2.488 Gbps downstream
2 10/100/1000BASE-T Ethernet Interface (LAN)
3 AC Power Adapter Input
4 Status LEDs
5 Reset Button
Fiber (FIBER)
GPON/Active Ethernet is supplied to the Micro ONT using an SC/
APC Fiber connection located on the rear of the unit.
Ethernet Interface (LAN)
The Micro ONT supports data service through one 10/100/
1000BASE-T Ethernet interface.
Power
The power feed is +12 VDC from the included AC to DC Adapter.
The adapter plugs into the PWR connector. The total power
consumption is approximately 5 watts.
ONT Reset (RESET)
Refer to Figure 1 for the location of the Reset button.
Reset the Micro ONT if you need to reboot the unit. The RESET
button is accessed through an opening on the bottom of the unit.
To reset the Micro ONT, insert a small pin (paper clip) into the
RESET opening and hold the button down for 10 seconds.
The Micro ONT will automatically download the latest provisioning
after the reset process has completed.
I
NSTALLATION
Before installing the Micro ONT, inspect it for damage. If damage
has occurred during shipping, file a claim with the carrier and then
contact ADTRAN. For more information, refer to the warranty.
Installation Guidelines
The following are guidelines for this installation.
■ Read all warnings and cautions before installing or servicing
the Micro ONT.
■ Do not locate the Micro ONT in direct sunlight or next to any
thermal obstructions.
■
When the SC/APC fiber connection is not in use, replacing the
Protective Cover will help keep the optical connection clean.
■
This product should not come in contact with water or other
liquids.
September 2020
61287786F1-13A
P/N: 1287786F1