Handling; Installation Procedure; Connecting To The Main Power Supply - Saturn FBGM12-B Instruction Manual

6. Handling

The GDM arrives in PET film and packed in a cardboard box on a wood pallet.
The GDM must be transported and handled with care. Never place
!
a GDM on its side or turn it upside down as this may damage or
impair operation of the refrigerated unit. Saturn cannot be held liable for
any damage or defects arising directly or indirectly from improper
handling of the equipment or non-compliance with the safeguards
illustrated above.
7. Installation Procedures
 Place the GDM in the coolest and best ventilated part of the room. Don't
install the GDM near heat and direct sunlight sources.

8. Connecting to the Main Power Supply

Qualified professionals must carry out this operation.
!
The refrigeration units are supplied complete with a power cord for the
connection to the main power supply. A thermomagnetic circuit breaker
Before proceeding make sure that:
© Saturn 2014 Version 2 | September 2014 | Glass Door Merchandiser
 Remove the straps securing the cardboard packing.
Remove the cardboard covering. Remove the PET
protection film.
 Adjust the leveling legs to isolate the casters from the
ground.
 Clean the GDM with mild detergent and then dry it with a
soft cloth.
 The unit should be installed more than 2" from any wall
and at least 8" of clear space above the unit.
 If you want to change the artwork in the light box, unscrew
the two screws on one of sides of light box, take off the
cover, pulling out the plastic artwork board from the
channels, replace with new plastic artwork board.
Reassemble light box.
(not supplied) must be installed between the main power
point and the power cord of the GDM.
Page 5