Error Code List - Fostex D-108 Service Manual

D-108
OL
0
3
6
9
12
18
24
30
42
If the Free Block indicates a large number even after formatting and no signal is recorded or recorded signals are frequently
skipped, the diskette / hard disk drive can be judged to be in a bad condition.

5. ERROR CODE LIST

The chart below indicates the error code number and corresponding description. Since the error code list is basically
designed for our engineers to improve the software, the description is quite technical. If you find the D-108 with one of
the error codes displayed, we encourage you to update the software first. In case updating the software does not solve the
problem, we would like you to inform us about details.
ERROR
CODE
1
3
9
10
11
12
14
15
16
20
21
22
30
31
32
35
36
38
40
41
42
45
52
60
61
62
63
64
96
97
99
22
1 2 3 4 5 6 7
D-108 ERROR CODE LIST
D-108 tries to access the address which does not exist.
SCSI drive does not boot up correctly when in SCSI access operation.
When saving system region sector, its address is registered in Free_block File during Free block File
checking procedure.
Link_pointer which links Audio File indicates smaller address (out of region) than Link_File address region
in RAM.
Link_pointer indicates larger address (out of region) than Link_File address region in RAM.
"Pointer_addre" calculation of Link_Pointer is not correct.
Link_Pointer during recording/reproducing indicates smaller address (out of region) than actual Link_File
address region.
Link_Pointer during recording/reproducing indicates larger address (out of region) than actual Link_File
address region.
"Pointer_addre" calculation of Link_Pointer during recording/reproducing is not correct.
src_cash_load: Improper access of link address occurred while PASTE editing.
bak_cash_load: Program link during PASTE/MOVE editing is incorrect.
bak_cash_load: Imcompatibility problem occurred on program link during PASTE/MOVE editing.
Error when executing MOVE editing. Improper Link Pointer. Error in "bak_cash_load" function.
Error when executing MOVE editing. Improper Link Pointer. Error in "bak_cash_load" function.
Error when executing MOVE editing. Improper Link Pointer. Error in "bak_cash_load" function.
Backup_Save:Error occurred when saving data to SCSI device.
Backup_Load: Error occurred when loading data from SCSI device.
Displayed in Test Mode only. SCSI device cannot be recognized during initial test.
dis_cah_load: Improper access occurred when recording/reproducing.
dis_cah_load: Improper access occurred when recording/reproducing.
dis_cah_load: Improper access occurred when recording/reproducing.
get_non_des_block: Remaining disk capacity is insufficient.
non_des_cash_save_sub: Improper access occurred when recording/reproducing.
remake_free_block: There was improper access to program management region.
remake_free_block: There was improper access to program management region.
remake_free_block: Number of manageable events exceeds limit.
remake_free_block: There was improper access to program management region.
remake_free_block: There is an overlapping section in program management region.
There was improper access to program management region.
There was improper access to program management region when saving System File.
There was improper access when fading in/out.
8
DESCRIPTION
44.1kHz