Download Print this page
SECO-LARM ENFORCER EV-5105-N1SQ Quick Start Manual

SECO-LARM ENFORCER EV-5105-N1SQ Quick Start Manual

Advertisement

Quick Links

ENFORCER Wall-Plate Camera
Troubleshooting:
The screen is blank.
The screen image is dim
The screen image has poor contrast.
The screen image flickers.
The screen image is distorted.
The camera case is hot.
IMPORTANT
Users and installers of this product are responsible for ensuring this product complies with all national, state, and local laws and
statutes related to monitoring and recording audio and video signals. SECO-LARM will not be held responsible for the use of this
product in violation of any current laws or statutes.
WARNING
Stop using the camera if you see a malfunction such as smoke or unusual heat, as it could cause fire or electric shock. Do not open
the case of this device, as there are no user-serviceable components inside.
FCC COMPLIANCE STATEMENT
Information to the user: This equipment has been tested and found to comply with the limits for a class B digital device, pursuant to
part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference when the equipment
is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of
this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the
interference at his or her own expense.
WARRANTY:
This SECO-LARM product is warranted against defects in material and workmanship while used in normal service for
a period of three (3) years from the date of sale to the original consumer customer. SECO-LARM's obligation is limited to the repair or
replacement of any defective part if the unit is returned, transportation prepaid, to SECO-LARM. This Warranty is void if damage is
caused by or attributed to acts of God, physical or electrical misuse or abuse, neglect, repair or alteration, improper or abnormal
usage, or faulty installation, or if for any other reason SECO-LARM determines that such equipment is not operating properly as a
result of causes other than defects in material and workmanship. The sole obligation of SECO-LARM, and the purchaser's exclusive
remedy, shall be limited to replacement or repair only, at SECO-LARM's option. In no event shall SECO-LARM be liable for any
special, collateral, incidental, or consequential personal or property damages of any kind to the purchaser or anyone else.
NOTICE
The information and specifications printed in this manual are current at the time of publication. However, the SECO-LARM policy is
one of continual development and improvement. For this reason, SECO-LARM reserves the right to change specifications without
notice. SECO-LARM is also not responsible for misprints or typographical errors. Trademarks are the property of SECO-LARM
U.S.A., Inc. or their respective owners.
Copyright © 2014 SECO-LARM U.S.A., Inc. All rights reserved. This material may not be reproduced or copied, in whole or in part,
without the written permission of SECO-LARM.
U.S.A., Inc.
16842 Millikan Avenue, Irvine, CA 92606
Tel: 800-662-0800 / 949-261-2999
4
• Check that the camera is powered up.
• Check that the power supply's polarity is correct.
• Check that the monitor is powered up.
• Check that the video cable connecting the camera to the
monitor is connected properly.
• Clean the lens using a soft, clean cloth.
• Check that the light source is adequate.
• Adjust the monitor's contrast knob.
• Change the position of the camera.
• Change the position of the camera.
• Change the position of the camera.
• Check that the correct power supply is in use.
Website: www.seco-larm.com
Email: sales@seco-larm.com
MiEV-51x5-x1SQ_141021.docx
SECO-LARM U.S.A., Inc.
EV-5105
5105-N1SQ
EV-5105
5105-P1SQ
EV-5145
5145-N1SQ
EV-5145
5145-P1SQ
Note: Each set includes only 1 camera.
Each set includes only 1 camera.
Each set includes only 1 camera.
PITSW1
Order Part# %764-100-5%
Wall-Plate Camera
Wall
Plate Camera
Manual
Manual
Includes 1 single
Includes 1 single-gang
(NTSC)
(NTSC)
and 1 slimline plate
and 1 slimline plate
(PAL)
(PAL)
(NTSC)
(NTSC)
Includes 1 European plate
Includes 1 European plate
(PAL)
(PAL)

Advertisement

loading

Summary of Contents for SECO-LARM ENFORCER EV-5105-N1SQ

  • Page 1 This SECO-LARM product is warranted against defects in material and workmanship while used in normal service for a period of three (3) years from the date of sale to the original consumer customer. SECO-LARM’s obligation is limited to the repair or replacement of any defective part if the unit is returned, transportation prepaid, to SECO-LARM.
  • Page 2 Min. wall thickness: Max. wall thickness: Install the angled rubber ring on the front of the plate so (See Dimensions.) ” (8mm) ” (20mm) that the camera is tilted. (Approximately 20°) ” (31mm) SECO-LARM U.S.A., Inc. SECO-LARM U.S.A., Inc.

This manual is also suitable for:

Enforcer ev-5105-p1sqEnforcer ev-5145-n1sqEnforcer ev-5145-p1sq