Hood Cover; Stop-Drop - Carrier 50EN Installation, Operation And Maintenance Instructions

Packaged rooftop units

Hood cover

The hoods for the fresh air and extraction air intakes (based on the
assembly selected) are supplied separately from the unit for assembly
on site by the installer.
The upper grip of the hood must be inserted from below the panel of
the upper box or from the lid in order to prevent water from entering.
Each hood is attached to the unit with Allen M4 screws (supplied with
the unit).

Stop-drop

The stop-drop can be installed in the indoor air coil and at the fresh
air intake.
- Indoor air coil: recommended
in cases where a high moisture
content in the air is foreseen or
when the air fl ow is high.
Note: With a hot water coil, it
is not possible to assemble a
stop-drop in the indoor air coil.
This optional is easily removable
from the side of the unit.
Stop-drop in the indoor coil
- Fresh air intake. The frames with the stop-drop have to be placed
after the hood (both supplied separated from the unit).
The frames with the stop-drop must be inserted behind the top fl ap
of the hood and then dropped over the rail.
Rail Top fl ap
25