Breville the AirRounder Plus LPH708 Instruction Book page 14

NOTE
The purifier fan heater will stop heating when
the ambient temperature is greater than the set
temperature (e.g. >25˚C). Ambient temperature
will flash, the light ring will no longer
illuminate, and oscillation will stop.
The unit will start heating again when the
ambient temperature is less than the set
temperature (e.g. ambient temperature < set
temperature 25˚C). Ambient temperature will
stop flashing, the light ring will turn on and
oscillation will resume at the same angle as
previously set, only if the oscillation button is
touched on the control panel or pressed on the
remote control.
Night Mode
Your purifier fan heater is fitted with a light-
sensitive sensor that will intelligently stop
the LED display screen and light ring from
illuminating at night or when in a dark place.
The Night mode will automatically turn off
the light ring and all lights on the LED display
panel and will operate in the last setting.
Touch any button on the control panel or press
any button on the remote control to re-engage
the LED display panel.
TIMER
AUTO-OFF TIMER
The purifier fan heater comes with a
7-hour auto-off timer to turn off after a set
number of hours.
The purifier fan heater can be set in 1 hour
increments up to 7 hours. After the selected
number of hours have elapsed, the purifier fan
heater will switch to standby mode. If no timer
is set, the purifier fan heater will continuously
operate until it is manually switched off.
AUTO-OFF TIMER Example: Set the auto-off
timer to 3 hours, and the purifier fan heater
will stop operating after 3 hours. 1h and 2h will
illuminate on the control panel LED lights.
The auto-off timer can be set in any MODE.
14
LPH708_ANZ_IB_B21_FA.indd 14 LPH708_ANZ_IB_B21_FA.indd 14
To set the timer, tap the
on the control panel or press on the remote
control until the desired number of hours
displays on the control panel LED lights. The
timer will start on the selected mode, and will
stop automatically once the timer has expired.
The control panel LED lights will illuminate
the remaining auto-off time.
REMAINING TIME Example: Set the
auto-off timer to 3 hours, once 1 hour has
elapsed, the remaining time will be displayed
in a decremental way, whereby 2h will
only illuminate on the control panel LED
lights, after another hour has elapsed 1h will
illuminate on the control panel LED lights until
the set time has completely elapsed.
To cancel the pre-set auto-off time, once the
timer is set, tap the button repeatedly
on the control panel or press on the remote
control until the number of hours no longer
illuminates on the control panel LED lights.
NOTE
The timer can be set on all modes and all
modes can be adjusted at any time once the
timer is set.
The purifier fan heater will switch to standby
mode once the set time has elapsed.
OSCILLATION
The purifier fan heater has horizontal
oscillation. The oscillation can be set
on all modes.
To activate oscillation, press the
repeatedly on the control panel or press on
the remote control to select between 60, 120
and 360 degrees, until the desired degree of
oscillation displays on the control panel LED
lights. The purifier fan heater will move left to
right continuously.
To stop and direct the orientation of your
purifier fan heater during oscillation, when the
airflow has reached your preferred position,
press the button repeatedly on the control
panel or press on the remote control until 60,
120 or 360 degrees is no longer illuminating
on the control panel LED lights.
button repeatedly
button
29/1/21 11:04 am 29/1/21 11:04 am