Troubleshooting; Feedback Form - Polaris 2881667 Manual

TROUBLESHOOTING

SYMPTOM
Dead vehicle
battery
Winch will not
operate
Winch makes noise
but rope/cable does
not move
Winch operates too
slowly
Winch will not
change gears

FEEDBACK FORM

A feedback form has been created for the installer to provide any comments, questions
or concerns about the installation instructions. The form is viewable on mobile devices
by scanning the QR code or by clicking
POSSIBLE CAUSES
Incorrect, damaged, or
corroded electrical
connections
Contactor not receiving
power
Incorrect, damaged, or
corroded electrical
connections
Keyed power circuit
(orange wires) not
properly powered
Contactor powered, but
not winch
Winch is improperly
loaded
Rope/cable is under
load
HERE
Instr 9926739
RECOMMENDED SOLUTION
Verify all winch electrical connections are per instruction
manual and free of damage and/or corrosion.
Turn vehicle key on.
Verify all winch electrical connections are per instruction
manual and free of damage and/or corrosion.
Check 10A accessory circuit fuse for continuity; replace as
required.
If clicking sound is heard when winch control button is
depressed, but winch motor is silent, then verify electrical
connections between winch and contactor are free of
damage and/or corrosion.
If winch makes noise but does not move, verify winch is in
gear.
If winch is in gear, but winch still does not move, have a
dealer inspect the winch.
Verify rope/cable is not binding on spool or fairlead.
Changing gears while under load is intentionally difficult to
prevent accidental operation, which could lead to personal
injury or winch failure. Ensure rope/cable is under no tension,
and rope/cable is not binding on spool or fairlead. Briefly
operate winch, then attempt to shift again.
if viewing on a PC.
Rev 02 2018-09 Page 9 of 9
FEEDBACK FORM