Toyota CAMRY PT949-08210 Installation Instructions Manual
Toyota CAMRY PT949-08210 Installation Instructions Manual

Toyota CAMRY PT949-08210 Installation Instructions Manual

Hide thumbs Also See for CAMRY PT949-08210:

Advertisement

TOYOTA
CAMRY
Preparation
Part Number:
PT949-08210 (Dashcam)
PT949-48210 (Y-Harness)

Dashcam Kit Contents

Item #
Quantity Reqd.
1
1
2
1
3
1
4
1
5
1
6
2
7
1

Y-Harness Kit Contents

Item #
Quantity Reqd.
1
1
2
2
3
4

Additional Items Required For Installation

Item #
Quantity Reqd.
1
1
2
1
Conflicts
N/A

Recommended Tools

Personal & Vehicle
Protection
Seat Protection
Dash Protection
Special Tools
PT949-IAD0E Install Aid
Installation Tools
Panel Tool
Socket Wrench
Torque Wrench
Hooked Panel Tool
Needle Nose Pliers
Special Chemicals
VDC Approved Cleaner
General Applicability
All Models
Recommended Sequence of Application
Item #
Accessory
1
Y-Harness (PT949-48210)
2
Dashcam (PT949-08210)
Issue: A 07/25/2021
(GAS AND HV)
Description
Dashcam Main Unit
SD Card Holder
SD Card (16 GB)
Window Mounting Plate
Foam Tape
Cable Ties
Quick Start Guide
Description
Mirror Patch Y-Harness
Foam Tape
Cable Ties
Description
PT949-08210 (Dashcam Unit)
PT949-48210 (Y-Harness)
Notes
Notes
For Port Installations Only
Notes
With 10 mm Socket
With 10 mm Socket
For Sun Visor Clip Removal
Notes
To Clean Windshield
*Mandatory
Page 1 of 16 pages
2022-
DASHCAM
Vehicle Service Parts
Item #
Quantity Reqd.
1
Up to 2 pcs
2
3
4
Kit Service Parts
Item #
Part Number
1
PT949-08210-AA
2
PT949-08210-AB
3
PT949-08210-AC
4
PT949-08210-AD
Legend
STOP: Damage to the vehicle may occur. Do not
proceed until process has been complied with.
OPERATOR SAFETY: Use caution to avoid risk of
injury.
CAUTION: A process that must be carefully observed
in order to reduce the risk of damage to the
accessory/vehicle and to ensure a quality installation.
TOOLS & EQUIPMENT: Used in Figures calls out the
specific tools and equipment recommended for this
process.
REVISION MARK: This mark highlights a change in
installation with respect to previous issue.
SAFETY TORQUE: This mark indicates that torque is
related to safety.
REGULATORY MARK: This mark indicates the
component is related to regulatory compliance
(Digital Video Recorder)
(may be required for reassembly)
Description
Roof Console Clips if damage
occurs during removal.
P/N: 90467-09240
(may be required in future)
Description
Camera Unit + SD
SD Card 16GB Industrial
Sd Card Holder Assembly
Window Plate with Tape

Advertisement

Table of Contents
loading

Summary of Contents for Toyota CAMRY PT949-08210

  • Page 1 TOYOTA CAMRY 2022- DASHCAM (Digital Video Recorder) (GAS AND HV) Preparation Part Number: PT949-08210 (Dashcam) PT949-48210 (Y-Harness) Dashcam Kit Contents Vehicle Service Parts (may be required for reassembly) Item # Quantity Reqd. Description Item # Quantity Reqd. Description Dashcam Main Unit...
  • Page 2 Vehicle Disassembly/Reassembly (panel removal, part storage, etc.). Electrical Component Disassembly/Reassembly (battery disconnection, connector removal, etc.). • Please see your Toyota dealer for a copy of this document. 1. Disconnect Battery (a) Protect the fender before starting. (b) The engine components and coolant may be hot.
  • Page 3 TOYOTA CAMRY 2022 - DASHCAM (Digital Video Recorder) (GAS AND HV) Procedure 4. Install Windshield Base Plate STOP: The front windshield must be at least 50°F (10°C). (a) For PPO Installations, please use 3D hard template with the part number “PT949-IAD0D”...
  • Page 4 TOYOTA CAMRY 2022 - DASHCAM (Digital Video Recorder) (GAS AND HV) Procedure For Dealer Installations / No 3D Hard Template Available: (g) Using scissors, cut the paper template as indicated. For PPO Installations, please use 3D hard template provided. (h) Referencing the TSS cover, align to the indicated line and affix the template to the windshield using tape.
  • Page 5 TOYOTA CAMRY 2022 - DASHCAM (Digital Video Recorder) (GAS AND HV) Procedure 6. Remove Roof Map Light Console (a) Remove the roof console by pulling down firmly on the forward edge (towards the front of the vehicle). Pull down to release...
  • Page 6 TOYOTA CAMRY 2022 - DASHCAM (Digital Video Recorder) (GAS AND HV) Procedure (b) Holding the TSS Cover firmly with both hands, move it downwards towards the windshield wiper cowl area by approximately 10 mm, without fully removing it. This is to get better access...
  • Page 7 TOYOTA CAMRY 2022 - DASHCAM (Digital Video Recorder) (GAS AND HV) Procedure 8. Install the Y-Harness (a) Disconnect the mirror power harness in on the release tab. The mirror harness is the 10-pin connector, outboard to the passenger side. (Fig. 8-1), (Fig 8-2) Fig.
  • Page 8 TOYOTA CAMRY 2022 - DASHCAM (Digital Video Recorder) (GAS AND HV) Procedure (4) Pull the remaining slack harness back into the headliner / map light console area as per the image. (Fig 8-5) Fig. 8-5 9. Route Dashcam Harness through the Headliner (a) From the driver’s side of the windshield,...
  • Page 9 TOYOTA CAMRY 2022 - DASHCAM (Digital Video Recorder) (GAS AND HV) Procedure (d) Connect the Dashcam pigtail harness to the newly fitted Y-harness that was fitted in step 7. (Fig 9-4) Fig. 9-4 (e) Apply the supplied Foam Tape to insulate the connectors from rattles.
  • Page 10 TOYOTA CAMRY 2022 - DASHCAM (Digital Video Recorder) (GAS AND HV) Procedure 11. Fitting the Dashcam to Base Plate NOTE: The Hang Tag that is attached to the Dashcam is only to be removed by the end user. As the camera turns on with...
  • Page 11 TOYOTA CAMRY 2022 - DASHCAM (Digital Video Recorder) (GAS AND HV) Procedure (c) Hook the Dashcam wire extension cover hooks into the leading edge of the headliner Fig. 11-5 (d) Swing the Dashcam unit up towards the base plate. Check for alignment of the 4 T-hooks Fig.
  • Page 12 TOYOTA CAMRY 2022 - DASHCAM (Digital Video Recorder) (GAS AND HV) Procedure 12. Route / Bundle Wire Harness (a) Before proceeding with securing the harness, confirm that both connector pairs and fuse holders have been protected with the provided foam tape.
  • Page 13 TOYOTA CAMRY 2022 - DASHCAM (Digital Video Recorder) (GAS AND HV) Procedure 13. Reinstall Overhead Console (a) Re-connect harness for the overhead console, test map lights and sunroof control if equipped. (Fig 13-1) (b) Check all console clips are in good condition and are present on the console.
  • Page 14 Page 14 of 16 pages Issue: A 07/25/2021...
  • Page 15 (Fig 17-3) (d) Optional: Use the Live View feature of the Toyota Integrated Dashcam phone application to confirm the view angle if compensating for other accessories / obstructions.
  • Page 16 TOYOTA CAMRY 2022 - DASHCAM (Digital Video Recorder) (GAS AND HV) Checklist - these points MUST be checked to ensure a quality installation. Check: Look For: Accessory Function Checks Removed items have been discarded & Verify parts replaced items are in place...

This manual is also suitable for:

Camry pt949-48210

Table of Contents