KitchenAid 5KSM45 Manual page 11

USING THE STAND MIXER
3
Insert attachment shaft housing into
attachment hub, making certain that
attachment power shaft fits into square
attachment hub socket. It may be
necessary to rotate attachment back
and forth. When attachment is in proper
position, the pin on the attachment will fit
into the notch on the hub rim.
5
To remove: Turn speed control to "0".
Unplug Stand Mixer.
7
Replace attachment hub cover. Tighten
attachment knob by turning it clockwise.
NOTE: See the Use and Care Guide of each specific attachment for recommended
speed settings and operating times.
W11389352A.indb 11
4
Tighten attachment knob by turning
clockwise until attachment is completely
secured to Stand Mixer. Plug into proper
electrical outlet.
6
Loosen attachment knob by turning it
counterclockwise. Rotate attachment
slightly back and forth while pulling out.
| 11
11/22/2019 11:52:28 AM