Before You Start; Back-To-Back Installation; Installation Instructions - American Standard Cadet PRO Series Installation Instructions Care And Maintenance

BEFORE YOU START:

Turn Off Water Supply
Recommended fitting type for
back-to-back installations.

INSTALLATION INSTRUCTIONS:

1
NOTE: 1/4" EZ-BOLTS INCLUDED.
IF 5/16" BOLTS ARE REQUIRED, PURCHASE SEPARATELY.
If Removing An Existing Toilet
Flush to remove water from tank;
sponge remaining water from bowl
before removing toilet.
Depending upon your plumbing and venting conditions, the flow from the toilet in
a back-to-back installation may create a vacuum on the system and draw water
from the opposing bowl. The National Standards Plumbing Code prohibits the use
of a cross fitting for drainage as throw over is possible. The code does approve a
directional "Y" style fitting with proper venting to direct the water downward and
away from the other toilet.
- 2 -
Clean Flange

BACK-TO-BACK INSTALLATION

2
Press firmly.
Caution: If leaving floor flange
!
open for more than 1-2 hours,
cover flange to prevent escaping
sewer gases.
Wax Ring
(sold separately)
7301878-100 Rev. 4 8/19