Mercedes-Benz E-Class Coupe Owner's Manual page 97

Soft top (Cabriolet)
94
Retracting AIRCAP
Turn the key to position 2 in the ignition
X
lock.
Open the cover on the lower centre con-
X
sole.
Press AIRCAP button :.
X
The two indicator lamps on the AIRCAP but-
ton go out. Wind deflector ; retracts. The
head restraints on the rear bench seats and
AIRCAP draught stop = move to the low-
est position simultaneously.
i
If there are passengers wearing seat belts
in the rear compartment, the head
restraints on the rear bench seats and the
AIRCAP draught stop remain in the upper
position.
Retracting the head restraints on the
rear bench seats from the driver's seat
To improve the rear view, you can retract the
head restraints on the rear bench seats indi-
vidually ( page 103). The wind deflector
Y
remains in its current position.
Fitting/removing the AIRCAP draught
stop
Preparation
You will need a 4 mm hex-socket wrench to
fit/remove the AIRCAP draught stop.
Before fitting or removing the AIRCAP draught
stop:
Turn the key to position 2 in the ignition
X
lock.
Open the folding roof fully (
X
Extend the head restraints in the rear com-
X
partment fully (
page 86).
Y
page 103).
Y
Removing
Bolts on the AIRCAP draught stop between the
head restraints in the rear compartment
Use the 4 mm hex-socket wrench to turn
X
the bolts on both sides anti-clockwise by
about 90° and loosen them.
Pull the bolts out of the brackets on the
X
head restraints.
Pull the AIRCAP draught stop out of the
X
guide rails in the direction of the arrow.
Make sure that you pull the AIRCAP draught
stop forwards slightly when doing so.