Safety
Safety and Instruction Decals
Safety decals and instructions are easily visible to the operator and are located near any
area of potential danger. Replace any decal that is damaged or lost.
Part No. 93-6688 (for CE)
1. Danger—read and
understand the operator's
manual before performing
any maintenance.
Specifications
General Specifications
Height-of-cut
Frequency of clip
(with variable speed set to
maximum RPM)
Bedknife to reel
adjustment
Suspension system
Specifications and design subject to change without notice.
2. Cutting hazard of hands or
feet—stop the engine
before approaching reel
area.
3/8 to 1-3/4 in. (10mm to 44mm)
1/2 to 2-5/8 in. with fixed cutting unit (13mm to 67mm)
5 blade at 1040 reel RPM at 5 MPH=1 in. clip (8 km/h = 25mm clip)
5 blade at 1040 reel RPM at 6 MPH=1.2 in. clip (9.7 km/h = 30.5mm clip)
8 blade at 1040 reel RPM at 5 MPH=.63 in. clip (8 km/h = 16mm clip)
8 blade at 1040 reel RPM at 6 MPH=.76 in. clip (9.7 km/h = 19mm clip)
11 blade at 1040 reel RPM at 5 MPH=.46 in. clip (8 km/h = 12mm clip)
11 blade at 1040 reel RPM at 6 MPH=.55 in. clip (9.7 km/h = 14mm clip)
Single knob screw adjustment for bedknife to reel, located at center of bedbar.
Each notch on the knob will move the bedknife .0005 inches (.013mm).
Fully floating with hydraulic counterbalance. L-I-N-K-S
system provides fore and aft oscillation. Main center pivot allows side-to-side
oscillation. With optional Fixed Kit, Part No. 93-6915, cutting units can be locked
into fixed (fore/aft) position for use with skids or anti-scalp rollers.
Part No. 67-7960
3
cutting unit suspension