Terminal
5.3 Schematic circuit diagram
5.2
Example of encoder type connection diagram for input signal DI0
Example
The connection diagram shows the connections for input signal DI
The pin assignment is as follows:
The figures below show the connections for input signal DI
NAMUR encoders / IEC 60947‑5‑6 encod‐
ers
Change-over contact connected with
10 kΩ (mechanical change-over contact)
5.3
Schematic circuit diagram
Definition
A block diagram is a schematic representation of the individual function blocks.
16
for all encoder types.
0
NAMUR change-over contacts /
IEC 60947‑5‑6 change-over contacts
Point of contact, unconnected (mechan‐
ical normally open contact with contact
point)
for all encoder types.
0
Point of contact connected with 10 kΩ
(mechanical normally open contact)
Change-over contact, unconnected (me‐
chanical change-over contact)
Equipment Manual, 08/2019, A5E39293880-AD
DI 16xNAMUR HA