Advertisement
10. Connecting ATX Power Connector
The ATX power supply uses 20-pin connector shown below. Make sure you plug in the
right direction.
11. Front Audio Connector
If the housing has been design with an audio port on the front panel, you'll be able to
connect onboard audio to front panel through this connector. By the way, please remove
the jumper cap from the Front Panel Audio Connector before you connect the cable. Do
not remove this yellow jumper cap if housing without an audio port on the front panel.
Pin 1
1
2
GND
MIC_IN2
+5V
MICBIAS2
RET_R
FRONT_R
KEY
NC
RET_L
FRONT_L
9 10
Del
+12V
+5V
5VSB
+5V
PW-OK
-5V
COM
COM
+5V
COM
COM
COM
+5V
PS-ON
COM
COM
+3.3V
-12V
+3.3V
+3.3V
You can use the autorun menu of Bonus CD disc. Choose the utility and driver and
select model name.
12. Power-on and Load BIOS Setup
After you finish the setting of jumpers and connect correct cables. Power on and
enter the BIOS Setup, press <Del> during POST (Power On Self Test). Choose "Load
Setup Defaults" for recommended optimal performance.
13. Aopen Bonus Pack CD
Warning: Please avoid of using "Load
Turbo Defaults", unless you are sure
your system components (CPU, DRAM,
HDD, etc.) are good enough for turbo
setting.
Advertisement
