Table of Contents
Advertisement
3-3 Jumper Setting
(1) Keyboard/USB function Enabled/Disabled: JP1
(2) CMOS RAM Clear (2-pin): JBAT1
A battery must be used to retain the motherboard configuration in CMOS RAM,
short 1-2 pins of JBAT to clear the CMOS data.
To clear the CMOS, follow the procedure below:
1.
Turn off the system and unplug the AC power
2.
Remove ATX power cable from ATX power connector
3.
Locate JBAT and short pins 1-2 for a few seconds, if shorted with the jump cap,
short for a few seconds then pull out the hat.
4.
Connect ATX power cable back to ATX power connector
Note: When should clear CMOS
1. Troubleshooting
2. Forget password
3. After over clocking system boot fail
HDMI_SPDIF_OUT
HDMI_SPDIF Header
JP1
1-2 Closed KB/USB Power ON Disable (Default)
Keyboard/ Mouse & USB Power On Setting
14 14
GND
1
2
JP1
2-3 Closed KB/USB Pow er ON Enabled
Advertisement
Table of Contents
