Philips S5000 Series Manual page 11

Problem
Water is
leaking from
the bottom of
the appliance.
Philips Quick Clean Pod
Problem
My shaver
isn't clean
after using the
Philips Quick
Clean Pod.
My Philips
Quick Clean
Pod does not
switch on.
00.049.0073.2 APA SDFU/IIB Bklt A6 FC 30x30 China.indd 11 00.049.0073.2 APA SDFU/IIB Bklt A6 FC 30x30 China.indd 11
Possible cause
During cleaning,
water may collect
between the inner
body and the
outer shell of the
appliance.
Possible cause
You removed the
shaver before the
cleaning program
was finished.
The Philips Quick
Clean Pod Cartridge
needs to be replaced.
The Philips Quick
Clean Pod is tilted.
The Philips Quick
Clean Pod is
powered by the
motor of the shaver.
The shaver is
connected to the wall
socket.
English
Solution
This is normal and not
dangerous because all
electronics are enclosed in a
sealed power unit inside the
appliance.
Solution
Leave the shaver in the
Philips Quick Clean Pod for
the full cleaning program.
Each cleaning program
takes approximately 1
minute. The cleaning icon
goes out when the cleaning
program is finished.
Replace the Philips Quick
Clean Pod Cartridge.
Place the Philips Quick
Clean Pod on a flat surface.
Place the shaver into the
Philips Quick Clean Pod.
Switch on the shaver.
Disconnect the shaver from
the supply unit.
11
07-08-20 09:33 07-08-20 09:33