Review The Network Deployment And Default Configuration - Cisco Firepower 1010 Getting Started Manual

Review the Network Deployment and Default Configuration

Review the Network Deployment and Default Configuration
The following figure shows the default network deployment for the Firepower 1010 using the default
configuration.
If you connect the outside interface directly to a cable modem or DSL modem, we recommend that you put
the modem into bridge mode so the ASA performs all routing and NAT for your inside networks. If you need
to configure PPPoE for the outside interface to connect to your ISP, you can do so as part of the ASDM Startup
Wizard.
Note If you cannot use the default Management IP address for ASDM access, you can set the Management IP
address at the ASA CLI. See
If you need to change the inside IP address, you can do so using the ASDM Startup Wizard. For example,
you may need to change the inside IP address in the following circumstances:
• If the outside interface tries to obtain an IP address on the 192.168.1.0 network, which is a common
• If you add the ASA to an existing inside network, you will need to change the inside IP address to be on
Cisco Firepower 1010 Getting Started Guide
164
Cisco Commerce Configure Licensing, on page
Workspace
Smart Software Configure Licensing, on page
Manager
ASDM Configure Licensing, on page
ASDM Configure the ASA, on page
(Optional) Change the IP Address, on page
default network, the DHCP lease will fail, and the outside interface will not obtain an IP address. This
problem occurs because the ASA cannot have two interfaces on the same network. In this case you must
change the inside IP address to be on a new network.
the existing network.
ASA Deployment with ASDM
171: Obtain feature licenses.
171: Generate a license token for the chassis.
171: Configure feature licenses.
175.
169.