Cisco Firepower 1010 Getting Started Manual page 138

Register the FTD with the FMC
Procedure
Step 1
In FMC, choose Devices > Device Management.
Step 2 From the Add drop-down list, choose Add Device.
Set the following parameters:
• Host—Enter the IP address or hostname of the FTD you want to add. You can leave this field blank if
you specified both the FMC IP address and a NAT ID in the FTD initial configuration.
• Display Name—Enter the name for the FTD as you want it to display in the FMC.
• Registration Key—Enter the same registration key that you specified in the FTD initial configuration.
• Domain—Assign the device to a leaf domain if you have a multidomain environment.
• Group—Assign it to a device group if you are using groups.
• Access Control Policy—Choose an initial policy. Unless you already have a customized policy you
know you need to use, choose Create new policy, and choose Block all traffic. You can change this
later to allow traffic; see
Cisco Firepower 1010 Getting Started Guide
136
Allow Traffic from Inside to Outside, on page
Firepower Threat Defense Deployment with a Remote FMC
115.