Babysit Mode On/Off; Backlight On/Off; Switch Call Barring On/Off - Motorola D710 Series User Manual

D711_IFU_EN_for_EU.book Page 16 Friday, August 24, 2007 3:58 PM

Babysit mode on/off

Leave one handset in a room and use another handset to hear sounds in that room.
m d m
1. Press , scroll to PERSONAL SET and press .
d m
2. Scroll to BABYSIT MODE. Press .
u d
3. Press or to select ON or OFF.
m
4. Press to confirm.
When switched On, you can leave this handset in the room you wish to monitor. Only the
microphone is on. Anyone in the room cannot hear you.
Babysit
1. Switch a handset's babysit mode setting On and place that handset in the room.
I
2. At a second handset, press and enter the number of the handset you are using as a room
monitor. You can now hear sounds coming from the room.
TIP
>
To stop room monitoring at any time, press

Backlight on/off

m d m
1. Press , scroll to PERSONAL SET and press .
d m
2. Scroll to BACKLIGHT. Press .
u d
3. Press or to select ON or OFF.
m
4. Press to confirm.
Keypad lock
Prevent accidental dialling while carrying the handset by locking the keypad.
*
1. Press and hold .
- The display shows KEYS LOCKED.
*
2. To unlock the handset, press and hold again.
NOTE
While the keypad is locked, you can answer incoming calls as normal.
16
8. Advanced settings
This setting is useful to access certain network and PABX/switchboard services.
Recall time
The default D711 recall time is suitable for your country and network operator. It is unlikely that
you should need to change this setting unless advised to do so.
m d m
1. Press , scroll to ADVANCED SET and press .
m
2. RECALL TIME is displayed. Press .
u d
3. Press or to select the setting you want: SHORT, MEDIUM, LONG.
m
4. Press to confirm.
>
5. Press to return to standby.
NOTE
The use of your D711 cannot be guaranteed on all PABX.
Dial mode
The default D711 dialling mode is suitable for your country and network operator. It is unlikely that
you should need to change this setting unless advised to do so.
m d m
1. Press , scroll to ADVANCED SET and press .
d m
2. Scroll to DIAL MODE. Press .
u d
3. Press or to select TONE or PULSE.
m
4. Press to confirm.
>
5. Press to return to standby.
Temporarily switch from Pulse to Tone dialling
*
1. Press and hold .
The dial mode will change from Pulse to Tone for the duration of the call.
Call barring
Prevent certain numbers from being dialled from your D711. Store up to four specific numbers,
each up to 4 digits – for example, international or local prefixes.
Bypass call barring by switching the setting Off or On.
NOTE
If you switch Call barring on, BARR MODE ON will be displayed on your screen in standby mode.

Switch call barring on/off

m d m
1. Press , scroll to ADVANCED SET and press .
d m
2. Scroll to CALL BARRING. Press .
3. Enter the master PIN (default setting 0000) and press
m
4. MODE is displayed. Press .
u d m
5. Press or to select ON or OFF. Press to confirm.
>
6. Press to return to standby. You can now set the number
(See below).
m
.
Advanced settings