Table of Contents
Advertisement
remote [exit|kexit]
ledb <p> <row> <ptn>
leds <row> [ptnstr]
keys
lcd <row> <col> <str>
clcd
beep [ms]
cls
reboot [watchdog]
serial_speed [test|fast|slow]
set_delays
host [auto/manual/charge/sync/off
[p] is port number
<m> is port mode
<|> is a list of profile IDs
<i> is a single profile ID
Parameters
Tab key
Cursor up
PP8S
Command
Notes
Action
showing system state)
Enter or exit mode where console is
controlled by terminal
Set individual LED on row <row>, port <p> to
flash bit pattern <ptn>
Set flash patternof a string of LEDs on row
<row> to string <ptnstr>
Read key click event flags
Write string <s> to LCD at row <row>, column
<col>
Clear LCD
Make console beep for [ms] milliseconds
Clear terminal screen
Reboot (optionally by using watchdog timeout)
Change serial interface speed
Change internal delays
Show if USB host is present, and set mode
change
Range 1....16. Omit for 'all'
c=Charge, s=Sync, o=Off, b=Biassed
Blank to use all profiles
Optional parameters are shown in [ ] Com-
pulsory in < >
Re-runs previous command
recalls last command
Page 13 of 18
Advertisement
Table of Contents
