Table of Contents
Advertisement
Available languages
Available languages
SWITCHING ON / OFF
Switching On
Using your thumb, push the On/Off switch (3) and hold
on. After a few minutes the device will have reached
operating temperature.
Switching Off
Release the On/Off switch (3) and the tool will switch off.
OPERATING INSTRUCTIONS [F1]
WARNING! Never hold the tool into
the fire or among the embers.
Lighting the barbecue
1.
Make a pile of charcoal or briquette.
2.
Touch the pile with the tip of the tool.
3.
Switch the tool on.
4.
Pull the tool backwards to 10-20 centimetres when
sparks or glow appear.
Continue pointing the tool towards the same spot for at
least 60 seconds (to ignite the charcoal) or a couple of
minutes (to get the charcoal white and ready to use).
5.
As soon as the fire starts, switch the tool off and
remove the plug from the electrical outlet.
Lighting the fireplace
1.
Make a pile of wood (preferably small and dry
pieces of wood).
2.
Touch the wood directly with the tip of the tool. In
order to make this operation faster, crumble a piece
of newspaper between the logs and touch the paper
directly with the tip of the tool.
3.
Switch the tool on.
4.
Pull the tool backwards to 10-20 centimetres when
sparks or glow appear.
5.
As soon as the fire starts, switch the tool off and
remove the plug from the electrical outlet.
ATTENTION! DO NOT ATTEMPT TO REPAIR THE PRODUCT BY YOURSELF AND DO NOT
TAMPER WITH IT! Any operation of repairing or extraordinary maintenance must be carried
out only by a qualified and authorized IVT Service Center. Do not try to modify any internal
part of the product! THIS WILL COMPLETELY VOID THE WARRANTY AND IT COULD CAUSE
SERIOUS INJURY AND DAMAGE.
MAINTENANCE AND STORAGE
Before any work on the device itself,
pull the mains plug.
∙
Always keep the tool and the ventilation slots (if
present) cleaned. Regular cleaning and maintenance of
the appliance will ensure efficiency and prolong the life
of your tool.
∙
If the tool should fail despite the rigorous
manufacturing and testing procedures, the repair should
be carried out by an authorized IVT customer service.
∙
Keep all nuts, bolts, and screws tight, to be sure the
tool is in safe working condition.
∙
Replace worn or damaged parts for safety.
∙
Use only original spare parts. Parts not produced
by manufacturer may cause poor fit and possible injury.
∙
Store the tool in a dry room out of reach of kids and
away from any flammable material.
∙
Never wet the device or spray water on it!
ENVIRONMENTAL PROTECTION
Recycle raw materials instead of
disposing as waste.
Tool, accessories and packaging should be sorted for
environment-friendly recycling.
The plastic components are labeled for categorized
recycling. These instructions are printed on recycled
paper manufactured without chlorine.
9
Instruction manual
EN
Advertisement
Table of Contents
